Berita

26-10-21

Push Button Continuity Tests: What the Beep Can and Cannot Prove

A push button continuity test can help check whether a documented contact changes between an open and a conducting state under an approved, deenergized.
26-10-21

Push Button Polarity: Separate the Switch Contacts from the LED

Push button polarity depends on which circuit you are connecting. An ordinary isolated mechanical contact is not automatically a positive or negative.
26-10-21

25mm Push Button Switch Guide

When selecting a push button switch for equipment, several factors should be considered, including contact configuration, wiring method, and electrical ratings. As a starting point for product selection, the panel mounting hole...
26-10-20

IP40 Switch Protection Inside Control Cabinets: Understand the Boundary

IP40 is an enclosure protection classification, not a statement that a switch is waterproof or dust-tight. The first digit concerns defined protection.
26-10-20

Relay Socket Retaining Clips: Qualifying Retention Under Vibration

A relay socket retaining clip should be selected as part of a documented relay, socket and accessory combination. Its job is mechanical retention within.
26-10-20

Push Button Mounting Depth: Allow Room for Wires and Service

Push button mounting depth must include the rear component assembly, the required wire exit, connection tools and service movement. The distance from the.
26-10-19

Wire Ferrules for Push Button Terminals: Compatibility Before Crimping

Wire ferrules can be used with a push button terminal only when the terminal's instructions permit the proposed ferrule, conductor and preparation method..
26-10-19

Screw vs Solder Push Button Terminals: Choose the Assembly Process

Choosing screw terminals or solder terminals for a push button is an assembly-process decision as well as a component decision. Start with the exact.
26-10-19

Cleaning Capacitive Touch Switches: Validate the Surface and the Output

Cleaning a capacitive touch switch requires two separate checks: the cleaning process must be compatible with the complete assembled surface, and the.
26-10-18

Industrial Key Switch Troubleshooting: Lock, Actuator or Contact Fault?

Industrial key switch troubleshooting begins by separating the key and lock mechanism, the rotary operator, the rear contact assembly and the machine's.
26-10-18

Industrial Push Button Sticking: Separate the Operator from the Circuit Fault

An industrial push button that sticks after installation needs a mechanical investigation as well as an electrical check. First establish whether the.
26-10-18

Replacing a Push Button Contact Block Without Changing the Operator

Push button contact block replacement starts with the identity of the complete assembly, not the diameter of the front button. Record the operator,.

1 2...30 Berikutnya > >>Page 1 / 30