Blog

gek

26-10-22

Push Button Insulation Resistance Tests: Define the Safe Test Boundary

A push button insulation resistance test needs a defined product configuration, test boundary, method and acceptance requirement before an instrument is.
26-10-22

Push Button Connectors: Verify Mating, Keying and the Complete Harness

A push button connector should be specified as a complete mating interface, including the device, mating component, contacts, wiring assignment and.
26-10-21

Push Button Continuity Tests: What the Beep Can and Cannot Prove

A push button continuity test can help check whether a documented contact changes between an open and a conducting state under an approved, deenergized.
26-10-21

Push Button Polarity: Separate the Switch Contacts from the LED

Push button polarity depends on which circuit you are connecting. An ordinary isolated mechanical contact is not automatically a positive or negative.
26-10-21

25mm Push Button Switch Guide

When selecting a push button switch for equipment, several factors should be considered, including contact configuration, wiring method, and electrical ratings. As a starting point for product selection, the panel mounting hole...
26-10-20

IP40 Switch Protection Inside Control Cabinets: Understand the Boundary

IP40 is an enclosure protection classification, not a statement that a switch is waterproof or dust-tight. The first digit concerns defined protection.
26-10-20

Relay Socket Retaining Clips: Qualifying Retention Under Vibration

A relay socket retaining clip should be selected as part of a documented relay, socket and accessory combination. Its job is mechanical retention within.
26-10-20

Push Button Mounting Depth: Allow Room for Wires and Service

Push button mounting depth must include the rear component assembly, the required wire exit, connection tools and service movement. The distance from the.
26-10-19

Wire Ferrules for Push Button Terminals: Compatibility Before Crimping

Wire ferrules can be used with a push button terminal only when the terminal's instructions permit the proposed ferrule, conductor and preparation method..
26-10-19

Screw vs Solder Push Button Terminals: Choose the Assembly Process

Choosing screw terminals or solder terminals for a push button is an assembly-process decision as well as a component decision. Start with the exact.
26-10-19

Cleaning Capacitive Touch Switches: Validate the Surface and the Output

Cleaning a capacitive touch switch requires two separate checks: the cleaning process must be compatible with the complete assembled surface, and the.
26-10-18

Industrial Key Switch Troubleshooting: Lock, Actuator or Contact Fault?

Industrial key switch troubleshooting begins by separating the key and lock mechanism, the rotary operator, the rear contact assembly and the machine's.

1 2...16 Volgende > >>Page 1 / 16