Notícias

26-10-07

Limit Switch Symbols: IEC and Ladder Diagram Examples

Read limit switch symbols, distinguish NO and NC reference states from PLC Boolean tests, and verify the exact device and drawing.
26-10-06

AC vs DC Relay Coils: Selection and Common Mistakes

Separate AC and DC coil requirements from contact ratings. Check voltage, frequency, power, suppression, release, and replacement compatibility.
26-10-06

Flyback Diodes for DC Relay Coils: Selection and Release

Understand DC relay coil flyback diodes, polarity, driver protection, built-in suppression, selection data, and release-time trade-offs.
26-10-06

Limit Switch Wiring: NO, NC and Changeover Contacts

Identify COM, NO and NC from the exact diagram, compare feedback paths, check controller interfaces, and verify actuator and machine response.
26-10-05

Three-Position Selector Switch Wiring for Hand–Off–Auto

Build a Hand–Off–Auto contact plan, distinguish controller and coil circuits, and check each mode, transition, and restart condition.
26-10-05

Two-Position Selector Switch Wiring for Hand–Off Control

Plan two-position Hand–Off control from the exact contact table, input or coil circuit, load rating, installation, and verified machine response.
26-10-05

Relay Contact Arcing: Causes and Suppression Methods

Learn why relay contacts arc, how load type affects suppression, and what to verify before adding an RC network, diode, MOV, or TVS.
26-10-04

Relay Failure Modes: Coil, Contacts and Mechanical Wear

Classify relay failures before replacing parts. Review coil supply, contact load, release behavior, socket faults, environment and failure evidence.
26-10-04

Momentary vs Latching Capacitive Touch Switches

Compare touch-following and retained outputs. Define event logic, supply and input interfaces, startup, power restoration, indication and testing.
26-10-04

Flashing vs Steady Indicator Lights for Machine Alarms

Choose flashing or steady machine indications from a clear state matrix. Define operator action, acknowledgement, lamp interfaces and visibility.
26-10-03

AC vs DC Indicator Lights: Matching the Panel Supply

Match a panel indicator to its declared AC or DC supply. Check exact variants, polarity, electronic outputs, leakage and the intended signal.
26-10-03

Indicator Light Symbols in Electrical Schematics

Read indicator lamp and LED symbols with device tags, supply notes, terminal maps and feedback sources. Match the drawing to the actual panel lamp.

1...4 5 6...30 Seguinte > >>Page 5 / 30