News

loca

Home
News

26-10-14

Electromechanical Relay vs Solid-State Relay: Choosing for the Load

Compare electromechanical and solid-state relays using actual loads, switching duty, off-state leakage, thermal design, controller inputs and fault response.
26-10-14

How an Electromechanical Relay Works: Coil, Armature and Contacts

Understand the electromechanical relay working principle: coil, armature, normal contact states and the difference between a button command and coil drive.
26-10-13

How to Qualify Piezo Switch Manufacturers: Evidence Checklist

Qualify piezo switch manufacturers using exact drawings, interface evidence, sample testing, certificate scope and production change controls.
26-10-13

Washdown Piezo Switches: Cleaning and Panel Qualification

Evaluate a washdown piezo switch against cleaning methods, chemicals, temperature changes, panel seals and rear enclosure protection before ordering.
26-10-13

Piezo Switch Circuit Design: Output and Controller Input Checks

Check a piezo switch circuit against PLC or microcontroller inputs: output type, pulse timing, leakage, lamp wiring and controlled interface validation.
26-10-12

Waterproof Emergency Stop Buttons: Sealing and Exposure Review

Select waterproof emergency stop buttons by rating scope, panel sealing and real exposure. Verify rear protection, outdoor conditions and operator action.
26-10-12

Emergency Stop Button Symbols: Contacts, Markings and Drawings

Understand emergency stop symbols, NC contacts, release arrows and device references. Match schematic meaning to the exact operator and contact assembly.
26-10-12

Emergency Stop Circuit Diagrams: Dual-Channel NC Review

Review emergency stop circuit diagrams: NC contact states, dual inputs, reset, output feedback and validation. Prepare a complete component enquiry.
26-10-11

Illuminated Selector Switches: Position and Lamp Feedback

Define illuminated selector switch contact states, lamp supply and indication meaning. Distinguish requested mode, accepted mode and actual operation.
26-10-11

Key Switch Removal Positions: Captive and Removable Keys

Specify key removal positions independently from contact states and spring return. Practical ordering and replacement checks for industrial key switches.
26-10-11

12V and 24V Key Switches: Contact Duty and Input Selection

Select 12V and 24V key switches by actual contact duty, PLC input compatibility, load type and lamp supply. A voltage label alone is not enough.
26-10-10

Waterproof Key Switches: Sealing and Environment Checks

Specify waterproof key switches by rating scope, panel sealing and real exposure. Check outdoor conditions, cleaning, condensation and rear-contact protection.

1 2 3 4...30 Next > >>Page 3 / 30